The factory manual hand-crank chute on the John Deere BM27737 44-inch snow blower works, but it’s slow, awkward, and frustrating to operate while seated on the tractor. Every chute direction change requires winding the crank repeatedly, and when you’re blowing snow around garages, walkways, driveways, fencing, and property edges, you end up doing it constantly.

The Push Industries 118.649 Electric Chute Rotation Kit permanently solves that problem. This upgrade replaces the OEM manual crank with a sealed 12-volt electric rotation drive controlled right from the tractor seat. No stopping. No reaching around. No fighting the crank. Just smooth, instant, precise chute rotation on demand. It makes snow blowing easier, faster, and a lot more enjoyable.

Important Fitment Note

This kit is only for the John Deere BM27737 44-inch snow blower. Deere has produced multiple 44" blowers over the years, and they are not the same. Before ordering, make sure your blower has the BM27737 tag on its identification sticker.

Tractor Compatibility

The BM27737 snow blower was factory-compatible with many John Deere 100-Series and S-Series tractors, including:

D105, D110, D125, D130, D140, D155, D160, D170
E100, E110, E120, E130, E140, E150, E160, E170, E180
S240
LA105, LA115, LA125, LA135, LA145, LA155, LA165, LA175

If your tractor runs the BM27737 44-inch snow blower, this kit is the correct electric rotation upgrade.

What the Kit Includes

• Electric rotation motor
• Switch box controller
• Wiring harness
• Mounting brackets and hardware

Bolt-on install. No drilling. No hydraulic hookups. Everything is included.

Designed for Expandability

The switch box and wiring harness are pre-configured to add our electric chute deflector actuator (Push Industries 118.501) at any time.

If you want both electric rotation and electric chute deflector control as a single integrated system, order the full upgrade package: Push Industries 118.651.

Recommended Pairing

For a fully electric BM27737 snow blower setup — rotation + deflector + lift — pair this kit with the Push Industries 118.555 Snow Blower Lift Kit, which replaces the weak OEM LP68150 electric lift assembly.

Why You’ll Love This Upgrade

• No more cranking a handle endlessly to steer the chute
• No more slowing down every time the chute needs to move
• Rotation happens instantly and precisely right from the seat
• Snow removal goes faster and feels dramatically less aggravating
• Snow placement becomes clean, accurate, and controlled

Built by People Who Actually Use This Equipment

Push Industries is USA-based and owned. Our products are designed, tested, and supported by equipment users who build the upgrades they run on their own machines.